Osmo UV-Protection Oil Tints Oak 5ml 425
£1.30
Osmo UV-Protection Oil Tints Oak 5ml 425
Osmo UV-Protection Oil Tints Oak 5ml 425S
CLEAR PROTECTION FOR VERTICAL STRUCTURES
- Highly water and dirt resistant
- Clear UV Protection Oil 410 is safe for humans, plants and animals when dry
- Clear UV Protection Oil 420 Extra is furnished with active ingredients to protect the coating against mould, algae and fungal attack
- Microporous, penetrating finish which does not crack, peel or flake
- No sanding necessary when topping up coating
- Delays natural greying by 12 times in comparison to untreated wood
- 410 CLEAREnhances the natural character of the wood. Supports a healthy living environment without the use of biocides to ensure the dry finish is safe for humans, plant and animal.
- 420 CLEAREnhances the natural character of the wood. Contains biocides to protect against algae, mildew and fungal attack.
FINISHES
Clear Satin
APPLICATION TOOL
Osmo Flat Brush or Osmo Microfibre Roller
RECOMMENDED USE
Vertical wood surfaces in outdoor areas
RECOAT
One coat, when signs of wear become visible
SIZES
5ml, 125ml, 750ml, 2.5L, 10L
DRY TIME
12 hours
CLEAN UP
Osmo Brush Cleaner
COVERAGE
18m²/L with one coat
COATS
2 coats
CARE
Osmo Spray Cleaner (Exterior)
SURFACE PREPARATION
Wood surface must be clean, dry and frost-free (moisture content max. 20%). Ideally, surfaces are sanded no finer than a P120 grit grade of sand paper. Sanding to finer grades will reduce required absorbency.
Osmo UV-Protection-Oil Exra is ready to use. Do not thin. Stir well using a flat stirring stick or spatula before use. If possible, and if the wood is an absorbent species, please apply the first coat to all sides before installation.
Fresh wood containing natural wood ingredients /extractives (eg: Cedar, Larch, Teak, Mahogany or Iroko) are often less absorbent and need to weather off first before applying the product. Please refer to website ‘Suitability’ section for more details. Weathering helps ingredient rich wood become more absorbent and the wood finish adheres optimally. Weathering is also required if ingredient rich wood has been freshly sanded or renovated.A coloured base coat is recommended, e.g. Natural Oil Woodstain. Coloured base coats can improve UV protection.
For renovations, clean old microporous wood finishes thoroughly. De-grey any weathered bare wood with Osmo Wood Reviver Power-Gel before applying an Osmo exterior product.
Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works. To maintain absorbency, avoid sanding surfaces finer than a P120 grit. Weather ingredient rich wood after sanding.
The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.
Soft wood species like Pine or Spruce are more prone to blue stain, rot and insects. If desired, pre-treat these soft woods if possible on all sides with Osmo WR Base Coat.Downloads