HG Hagesan satin gloss polish For unglazed quarry tiles, floor tiles and slate. Apply a very thin film of HG satin gloss polish (HG golvpolish). Consequently, the pores are completely sealed and dirt cannot penetrate into the substructure. It deepens the colour and gives a lovely silky luster at the same time. Apply HG satin gloss polish (HG golvpolish) equally in one direction with a paint roller or a lint-free cloth. Allow to work in for a maximum of 5 minutes. Then remove the surplus substance with a dry cloth. One litter is enough for a surface area of 8 to 10 m².
Prior to applying HG satin gloss polish HG golvpolish the floor should bethoroughly cleaned, preferably with HG Polish, Wax and Dirt Remover to clean off grease, old layers of wax etc. After wet cleaning the floor should be left to dry thoroughly for 3 days. With floor heating 24 hours. Turn off your floor heating 12 hours before treatment. On porous surfaces such as slate, brick or flagstones first use HG impregnating sealer HG impregnator. To avoid foam, do not stir or shake the bottle before use. The HG satin gloss polish HG golvpolish should be applied with a fluff-free cloth, e.g. a used teacloth wrapped around a squeegee, or, on rough surfaces, use a velvet paint roller suitable for acrylic paint. Pour some HG satin gloss polish HG golvpolish on the cloth and always spread the polish in one direction. Do not rub or buff. Once the HG satin gloss polish HG golvpolish has dried after approx. 40 mins. A second coat should be applied at right angles. Dries after 3 hours, but allow 3 days for the HG satin gloss polish HG golvpolish to become fully water resistant.
Maintenance: With HG shine cleaner HG superfloor. To strip off old coats of HG satin gloss polish HG golvpolish annually use HG polish, wax and dirt remover HG remover.
