HG Hagesan laminate gloss coating  If HG laminate gloss coating is applied neat, it forms a very fine layer which protects the floor against scratching and wear. In addition, the product gives the floor a pleasing, rich shine. Apply HG laminate gloss coating with a clean, non fluffy cloth wrapped around a floor wiper. Spread evenly in one direction. Wait 45 minutes and then apply the second coat at right angles to the first. The finish will have completely hardened after 24 hours. One litre is enough for a surface area of about 60 m².  NB: do not use this product on click laminate!

DIRECTIONS FOR USE

To prevent variations in the depth of shine, it is recommended that oldHG laminate gloss coating  coats are removed before a new coat is applied. Use HG  laminate powerful cleaner  for this purpose (undiluted). If HG laminate glosscoating  is being applied for the first time, always clean the floor thoroughly beforehand (including new floors) using HG   laminate powerful cleaner  (1:5). Aftercleaning, allow the floor to dry completely before applying HG  laminate glosscoating . The best results are obtained by using a sponge squeegee mop overwhich a plastic bag has been placed. The plastic bag should then be covered with aclean, damp, lint-free (tea) cloth. Using a clean cloth, apply the HG  laminate glosscoating  to several spots on the floor and then spread it out evenly in one direction(do not allow the laminate shine to soak into the seams). Do not scrub or rub!After approx. 45 minutes, the HG  laminate shine  will be dry and a second coat(e.g. for extra shine or greater resistance) can be applied at right-angles to the firstcoat. The coating will have hardened completely in 24 hours. Add one cap-full ofHG  laminate gloss coating  per liter of water and use this solution to wash/mop thefloor. Ensure that the floor cloth/mop is not too wet. Rinse out the floor cloth/mopregularly in a bucket of clean water. Do not rinse or dry.